Index - JVC GR-DVL315A Instructions Manual

84
EN
Indications
INSERT ERROR!
INSERT ERROR!
<CANNOT EDIT
ON A LP RECORDED
TAPE>
<CHECK TAPE'S ERASE
PROTECTION TAB>
MEMORY IS FULL
COPYING FAILED
MEMORY CARD!
PLEASE
FORMAT
NO IMAGES STORED
CARD ERROR!
CHECK CARD'S WRITE
PROTECTION SWITCH
E01 — E06
UNIT IN SAFEGUARD
MODE REMOVE AND
REATTACH BATTERY
Appears if Insert Editing is attempted on a blank portion of a tape.
Appears if Insert Editing is attempted on a tape recorded in the LP mode.
Appears if INSERT (w) on the remote control is pressed when the erase
protection tab is set to "SAVE".
Appears when the memory card's memory is full and shooting is not
possible.
Appears if dubbing of copyguarded signals is attempted while this
camcorder is being used as a recorder.
Appears in the following cases when dubbing from a tape to a memory
card:
– when no memory card is loaded.
– when the memory card's memory is full.
– when the memory card is not formatted.
– when a copy-protected SD Memory Card is loaded.
Appears in the following cases when dubbing still images stored in the
memory card to a tape:
– when condensation occurs.
– when no tape is loaded.
– when the erase protection tab is set to "SAVE".
– when a tape in another format is loaded.
– when the tape ends.
Appears if a memory card is not loaded when SNAPSHOT is pressed while
the Power Switch is set to "
to " ".
Appears when there is a problem with a memory card and its memory is
corrupt, or it has not been initialilsed. Initialilse the memory card.
Appears if there is no images stored in the memory card when the Power
Switch is set to "
Appears when the camcorder takes more than 60 seconds to recognize the
loaded memory card. Remove the memory card once and insert it again.
Repeat these procedures until no indication appears. If the indication still
appears, the memory card is corrupted.
Appears when you attempt to shoot digital still images while a copy-
protected SD Memory Card is loaded.
The error indications (E01 — E06) show what type of malfunction has
occured. When an error indication appears, the camcorder turns off
automatically. Remove the power supply (battery, etc.) and wait a few
minutes for the indication to clear. When it does, you can resume using the
camcorder. If the indication remains, consult your nearest JVC dealer.

INDEX

Function
" or " " and the VIDEO/DSC switch is set
" and the VIDEO/DSC Switch is set to "
Indications (cont.)
( pg. 67)
( pg. 67)
( pg. 67)
( pg. 56)
( pg. 55)
( pg. 26)
( pg. 36)
".