Rheem RTGH-95DV Use And Care Manual page 58

INSTALLATION INSTRUCTIONS
Electrical Wiring
Remote Control Selection and
Location
WARNING:
and electrical grounding must comply with local
codes or, in the absence of local codes, with the
latest edition of the National Electrical Code, ANSI/
NFPA 70, in the U.S., or Canadian Electrical Code,
CSA C22.1, Part 1, in Canada.
NOTICES:
• The provided remote control will allow maximum
temperature settings of 120°F (49°C). Temperatures
up to 140°F (60°C) for residential applications and
up to 185°F (85°C) for commercial applications*
can be achieved with the MAIN (UMC-117) remote
control. Only qualified service personnel should
perform this adjustment.
One remote control is provided with the water
heater. Additional remote controls may be
purchased separately. The available remote
controls are listed in the following chart. Up to
three remote controls can be used with the water
heater. No other manufacturer's controls are
suitable for use with this water heater.
Remote Control
Model Number
UMC-117
USC1-117
USC2-117
MIC-6 or MIC-185**
Manifold System
*A commercial conversion kit can be purchased to achieve temperatures up to 185°F (85°C).
**When a manifold system is installed, the main remote control connected to the manifold controller
(MIC-6 or MIC-185) has priority over the remote controls connected to the water heater.
58
(cont.)
Field wiring connections
• An optional cable (EZ Link
Cable ) can be purchased
TM
separately to manifold two
water heaters together.
• Do not attempt to disassemble
a remote control. All controls are
sealed and calibrated for accurate
water heater control and operation.
Remote Control
Description
MAIN
BATH 1
BATH 2
Manifold System
Review the following considerations before
determining the location of the remote
control(s):
• Do not install any remote control
outdoors or where it can come in
contact with water.
• Avoid installing the remote control in
the following areas and/or conditions:
– area exposed to heat.
– area exposed to steam.
– area exposed to oil.
– area exposed to direct sunlight.
– areas near stored or used
• Place remote control out of children's reach.
• The remote control should be installed in a
convenient location (e.g., kitchen, laundry room,
utility room, or directly next to the water heater).
• The maximum distance between the water
heater and the remote control installation
location is limited to 195 ft. (59 m) of wire.
Temperature
Set Point Range
100°F–120°F (38°C–49°C)
85°F (29°C)
125°F–140°F (52°C–60°C)
85°F (29°C)
125°F–185°F (52°C–85°C)
100°F–120°F (38°C–49°C)
85°F (29°C)
100°F–120°F (38°C–49°C)
85°F (29°C)
flammable products.
Availability
Factory Default
Qualified Technician
Adjustment for Residential Products
Qualified Technician
Adjustment for Commercial Products*
Optional (Sold Separately)
Qualified Technician Adjustment
Optional (Sold Separately)
Qualified Technician Adjustment
Optional (Sold Separately)