Operating The Printer; Description Of Each Part; Outside View; Operator Panel - Fujitsu 9811 ATB Operator's Manual

Operating the Printer

Description of each part

1. Outside view

Form out
Error
Ready
7 9
8
4 5 6
1 2 3
0
RST
EJT
Power ON/OFF switch

2. Operator panel

Several messages are shown on the LCD display.
Status of the printer is indicated through the LED indicator.
Form out means the end of the coupon stock, when blinking it means that the ribbon has fewer
than 150 coupon prints left.
Error means error, please refer to the message describing the error on the LCD display.
Ready means the printer is working on line.
Receive means the printer is receiving data from the host computer
Transmit means the printer is sending a response to the host computer.
Key functions for the operator.
1. ON/OFF key is used for changing On line to Off line and the reverse.
2. RST key means reset an abnormal condition on the printer.
3. To clean the magnetic head, please push keys " ON / OFF" and then " 1 ".
This coupled key usage puts the printer into Cleaning mode.
Please insert the cleaning card into the front insertion slot in the cleaning mode
4.Pushing " 4 " show the software version on the LCD display.
※Other keys are used for maintenance.
Buzzer
Buzzer indicates Stacker Full, Ribbon End, Jam Error, other hardware errors and communication data error.

3. Inside the printer

The following have been colored green in the diagram to assist location.
1.Clamp for Ribbon cassette, 2.Button for paper guide, 3.Knob for feeding roller, 4 Presser for nip
roller, 5.Lever for insertion shutter and 6.Lever to nip roller to remove a paper jam.
Knob for feeding roller
Lever for insertion shutter
Floppy disk drive
LCD display
LED indicator
Receive
Transmit
Power
on /
Key pad
off
TST
+／
－
ENT
Insertion slot
Clamp for Ribbon
Bin1, Green
Coupon
Bin3, Green
Coupon
Bin2, Blank
Coupon
1
Presser for nip roller
Button for paper guide
Bin feeder
Bin door
Key lock