Operations - JVC SP-DW103 Instructions Manual

Operations

Front view
Rear view
MIN
ı
MAX
VOLUME
Î
AUTO POWER ON/STANDBY
PHASE
‰
AUTO POWER
ON/STANDBY
Å
POWER
POWER
Power
lamp
VOLUME FREQUENCY
50Hz
Ç
200Hz
FREQUENCY
CUT OFF FILTER
PHASE
NORMAL VARIABLE
REVERSE FIXED
Ç
CUT OFF
RIGHT LEFT/MONO
ON INPUT 1
FILTER
CANCEL
(LOW-LEVEL)
RIGHT LEFT
INPUT 2
(HIGH-LEVEL)
TO MAIN
SPEAKERS
RIGHT LEFT
OFF ON
The unit automatically accommodates AC power between
110V and 240V. You do not need any setting to match the
unit with your local power voltage.
Turning On the Power—POWER Å
Press the ON [ ❙ ] portion of the POWER switch.
The main power turns on and the power lamp in the front panel
lights in green.
• The power lamp lights in red when the Auto Power On/
Standby places the unit into standby mode (see page 4).
To completely cut off the power to this unit
Press the OFF [ ‡ ] portion of the POWER switch.
This will disconnect the mains lead.
Adjusting the Volume—VOLUME ı
Adjust the volume output level through this unit while comparing
with the sounds coming out of the main (front) speakers.
• Once you have adjusted the volume output level of this unit,
you do not need to adjust it each time you use this unit.
Adjusting the volume level on the connected amplifier will also
adjust the volume level through this unit.
1
Turn the VOLUME knob to the MIN position.
MIN
MAX
2
Turn on the connected amplifier and start playing a
source.
Playback sounds come out of the main (front) speakers and
this unit.
3
Adjust the VOLUME knob to obtain a well-balanced sound
level with that of the main (front) speakers.
MIN
MAX
If the volume is set at a high level before starting play, the
sudden blast of sound energy can permanently damage
your hearing and/or ruin your speakers.
– 3 –
VOLUME
VOLUME