Installing The Stand; Disconnecting The Stand - Samsung 8500 Series User Manual

Problem Possible Solution
Image is not stable and may
appear to vibrate when you have
a computer connected to the PC
input.
If the setting is not correct, use your computer utility program to change the display
settings.
Your TV supports multiscan display functions within the following frequency domain:
- Horizontal frequency (KHz): 30-60 .
- Vertical frequency (Hz): 60-75
- PC Maximum refresh rate (at 60 Hz): 1920 x 1080
- - - - - - - - - - - - - - - - 1 - - - - - - - - - - - - - - - - - - - - - - - - - - - -
Image is not centered on the Adjust the horizontal and vertical position.
screen. The screen position must be adjusted on the output source (i.e, STB) with a digital signal.
The picture appears distorted in the If
Screen Fit
is selected with some external devices, the picture may appear distorted in
corner of the screen. the corner of the screen. This symptom is caused by the external devices, not TV
The 'Resets all settings to the This appears when you press and hold the
EXIT
button for a while. The product settings
default values.' message appears, are reset to the factory defaults.
IEJ
This TFT LED panel uses a panel consisting of sub pixels (6 220 800) which require sophisticated technology to produce.
However, there may be few bright or dark pixels on the screen. These pixels will have no impact on the performance of the
product.
I
Installing th_e_S_ta_n_d _
~
Preset: Place the Guide Stand and Cover Neck onto the stand and fasten it using
the screws,
1. Attach your LED TV to the stand,
~
Two or more people should carry the TV
~
Make sure to distinguish between the front and back of the stand when
attaching it.
~
To make sure the TV is installed on the stand at a proper level, do not apply
excess downward pressure to the upper left or right sides of the TV
2. Fasten screws at position
0
and then fasten screws at position
e.
~
Stand the product up and fasten the screws. If you fasten the screws with the
LED TV placed down, it may lean to one side,
I
Disconnecting the Stand
1. Remove screws from the back of the TV,
2. Separate the stand from the TV
~
Two or more people should carry the TV
3. Cover the bottom hole with the cover.