Summary of Contents for RedMax SU-I
- Page 1 SU-I Subscriber Indoors Quick Install Guide 70-00077-01-03 Proprietary Redline Comm. © 2010Page July 23, 2010 4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299...
-
Page 2: Copyright Information
SU-I Quick Install Guide Copyright Information All rights reserved July 23, 2010. The information in this document is proprietary to Redline Communications Inc. This document may not in whole or in part be copied, reproduced, or reduced to any medium without prior consent, in writing, from Redline Communications Incorporated. -
Page 3: Safety Notices For Su-I Indoor Modem (Su-I)
3.650 GHz. More information regarding licensing requirements is available from Industry Canada (www.ic.gc.ca). Attention: The SU-I front grill is used to dissipate heat and may feel quite warm during normal operation. Avoid direct contact with this feature when handling the SU-I. -
Page 4: Introduction
SU-I Quick Install Guide The RedMAX indoor wireless access subscriber modem is a fully integrated WiMAX Forum compliant device incorporating an Ethernet interface and wireless interface to a WiMAX base station. Mounting options are available to accommodate desktop, window, and wall mount. -
Page 5: Installation Summary
SU-I Quick Install Guide The following simple steps are needed to setup your RedMAX SU-I: Figure 2: Subscriber Power and Network Connections Step 1: Unpack SU-I Components The following accessories are supplied in the SU-I package: Figure 3: Subscriber Accessories 70-00077-01-03 Proprietary Redline Comm. - Page 6 Step 3: Position SU-I with an Unobstructed View of Window. The SU-I must be located near a window. The SU-I can be located on any flat level surface such as a window sill, shelf or table. If this is not practical, you may order a wall mount bracket for the SU-I.
- Page 7 Search Mode When powered-on, a walking LED pattern is displayed while the SU-I searches for WiMAX base stations. Note: Do not move the SU-I while the search is in-progress. When the search is completed, the walking pattern stops and the LEDs indicate received signal strength.
-
Page 8: Troubleshooting
When the base station antenna is not visible from the SU-I location, it is still be possible to receive a strong signal reflected from nearby buildings. - Page 9 Important: The antenna is located on the back of the SU-I. When you have located the SU-I position with the strongest signal, set the SU-I on its side and observe the effect (if any) on signal strength. If increased signal strength is detected in this position, you should user the horizontal mount option.
- Page 10 SU-I Quick Install Guide Low Signal / No Connection to Base Station a) The subscriber requires visual line-of-sight (LOS) to receive the best signal, and must typically be located as close as possible to a window. b) Some office buildings use tinted windows to reduce heat. If the tinting uses metal embedded in the glass, this may act as an RF shield and greatly reduce the available signal level.
- Page 11 SU-I Quick Install Guide Notes: 70-00077-01-03 Proprietary Redline Comm. © 2010 Page 11 of 12 July 23, 2010 4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299...
- Page 12 70-00077-01-03 Proprietary Redline Comm. © 2010 Page 12 of 12 July 23, 2010 4Gon www.4Gon.co.uk info@4gon.co.uk Tel: +44 (0)1245 808295 Fax: +44 (0)1245 808299...