Table of Contents
Advertisement
Securing the appliance
Fit the appliance into column unit until the front
frame of the oven is aligned to the cupboard
opening. Ensure the appliance is stable and not
leaning. Do not crush the power supply cord.
Fix the oven in position with 4(four) 3 x 20mm
screws provided. The fixing points are located
on the top and bottom corners of the oven. Do
not over tighten screws.
Check that it is correctly aligned.
Check that the door is free to open and close.
Connect the power supply cord.
Turn on the power mains. The appliance must
only be operated when it has been built in to
avoid electric shock hazard.
Connecting the supply cable to the power mains
Install a standardized plug corresponding to the
load indicated on the rating label attached to the
appliance.
If the appliance is being directly connected to the
power mains supply, an omnipolar circuit breaker
must be installed with a minimum gap of 3mm
between the contacts, suitable for the load
indicated and complying with current electrical
regulations (the earthing wire must not be
interrupted by the circuit breaker). The supply
cable must not come into contact with surfaces
with temperatures higher than 50
The installer must ensure that the correct
electrical connection has been made and that it is
compliant with local safety regulations.
Before connecting to the power supply, ensure
that:
The appliance is correctly and efficiently earthed.
The socket can withstand the maximum power of
the appliance, and voltage within the value range
Secure appliance to
indicated on the rating label attached to the
housing unit using
appliance.
4(four) Screws
ST3x20 mm.
The basic safety requirement should be tested by
a qualified technician. Multiple plugs and
extension cables must not be used. Overloading
is dangerous and may cause a fire hazard.
Once the appliance has been installed, the power
supply and electrical socket must be easily
accessible.
The installer must ensure that the correct electrical
connection has been made and that it is compliant
with local safety regulations.
The manufacturer declines any liability should
these safety measures not be observed.
16
0
C.
Advertisement
Table of Contents
