GE Series 2000 Installation Instructions Manual page 3

2021403-028A
3. Insert the wood front handrail into the metal side rails, then align the pre-
drilled holes and screw in the two Phillips screws on both sides. Assemble the
side rails in the same way.
4. Install the two grommets on the front rail assembly.
5. Place the assembled front handrail into the metal mounting brackets on the
front corners of the shroud. Using the supplied Allen wrench and four bolts,
secure the handrail to the brackets.
6. Place the assembled side rails into the side mounting holes and screw in the
two bolts on each side. Refer to the drawing below for designation of right
side and left side handrails.
Side Rail
Mounting Hole
Left Side
7. Attach the side rails to the front rail with the mated T-brackets. Tighten the
two T-bracket bolts with the Allen wrench.
8. Make sure all screws and bolts are seated properly and no sharp edges are
present.
9. Reassemble the shroud and align the grommets properly.
Series 2000 Treadmill
T-Brackets
Right Side
Shroud Back
Grommet
Notch
Front Handrail
Mounting Bracket
A notch designates
Right Side Handrail
from Left Side
Handrail.
Notch
003
3