CITROEN C3 Picasso 2013 Owner's Handbook Manual page 160

11
PRACTICAL INFORMATION
 Switch on the compressor by moving
the switch B to position "1" until the
tyre pressure reaches 2.0 bars.
 Remove the kit, taking care to avoid
staining your vehicle with traces of
fl uid. Keep the kit to hand.
 Drive immediately for approximate-
ly three miles (fi ve kilometres), at
reduced speed (between 15 and
35 mph [20 and 60 km/h]), to plug
the puncture.
 Stop to check the repair and the tyre
pressure using the kit.
 Turn the selector A to the AIR posi-
tion.
 Connect the black pipe D to the
valve of the wheel.
120
i
If after around 5 to 7 minutes the
pressure is not attained, this indi-
cates that the tyre is not repairable;
contact a CITROËN dealer for as-
sistance.
i
Checking/Adjusting tyre
pressures
You can use this kit to infl ate other
accessories such as a ball or bi-
cycle tyres.
To do this, turn the selector to the
"Infl ation (AIR)" position, connect
the black pipe with the appropri-
ate adaptor to the accessory to be
infl ated, then follow the rest of the
procedure below as far as removal
of the kit.
You can also use this kit for rou-
tine checking and adjustment of
the tyre pressures on your vehicle.
For this, carry out just the following
6 points.