D Editing The Receive (Rx) And Transmit (Tx) Frequencies; D Selecting The Rx And Tx Tones - Icom Iç-V88 Operating Manual

5
FRONT PANEL PROGRAMMING
Front Panel Programming mode (Continued)
D Editing the Receive (RX) and Transmit (TX)
frequencies
These instructions are the same to edit both the RX
and TX frequency.
While a zone and a channel number are displayed,
q
as described on page 7, push [UP] to first select the
RX frequency, or push it again to select the TX fre-
quency.
• When you select the RX frequency, the LED indicator
lights green, and when you select the TX frequency, the
LED indicator lights red.
RX frequency:
TX frequency:
Push [P3] to enter the Frequency Edit mode.
w
• The cursor blinks at the first digit.
Enter a desired frequency by pushing the keys on
e
the 10-key pad.
After you finish entering all digits, or push
r
frequency will automatically be saved.
• The cursor stops blinking.
LED: Green
LED: Red
[P3], the
8
D Selecting the RX and TX tones
These instructions are the same to select both the RX
and TX tones.
While the TX frequency is displayed as described on
q
page 8, push [UP] to first select the RX tones, or
push it again to select the TX tones.
• When you select the RX frequency, the LED indicator
lights green, and when you select the TX frequency, the
LED indicator lights red.
RX tones screens:
• RX CTCSS tone frequency OFF
• RX CTCSS tone frequency
• RX DTCS code
TX tones screens:
• TX CTCSS tone frequency OFF
• TX CTCSS tone frequency
• TX DTCS code
LED: Green
LED: Green
LED: Green
LED: Red
LED: Red
LED: Red
Continued on the next page.
☞