Initial Setup; Auto Tuner Setup; Channel Summary - JVC AV 27020 User Manual

AUTO TUNER SETUP

During Auto Tuner Setup, the TV w i l l
automatically scan through all available
channels and memorize the active ones
so that when you scan, you do not pick
up weak or noisy channels.
Press the M
ENU
To AUTO TUNER SETUP
To operate
TUNER MODE :
START
To choose CABLE or AIR
To move to START
To start Auto Tuner Setup
NOW
PROGRAMMING!
48
The Programming takes approximately
1 to 2 minutes
PROGRAMMING OVER!
Note: Noise Muting will not work while
Auto Tuner Setup is working.
I N I T I A L
channel scanning. You can also lock out
button
CABLE AIR
delete it by removing the
Note: Some cable systems experience

CHANNEL SUMMARY

You can add or delete channels from the
any "unauthorized" viewers from one or
up to all 181 channels.
Press the M
ENU
To CHANNEL SUMMARY
To operate
ADD
You can manually set channels to scan
that were too weak to be picked up
during Auto Tuner Setup. (If you have not
performed the Auto Tuner Setup, in
previous column, do so now.) Conversely,
if a channel was too weak to receive a
good picture but was picked up anyway,
CH ADD :
0 1 – – :
0 2 X – :
0 3 X – :
0 4 X – :
0 5 X – :
To the ADD column
To include or delete from scan
E when finished
XIT
Note: Channels set to scan will be
X.
marked with an
interference from radio frequencies on
Cable Channel 95. You can delete this
channel f rom scanning by removing the X.
Continued next page ...
S E T U P
button
X .
CH ADD
06 X –
07 – –
08 – –
09 X –
10 X –
3
1
NOTES:
During Initial Setup,
the TV will be
programmed to
only receive active
channels. Once the
channels are
activated by the
Auto Tuner Setup
they will be includ-
ed in Scan.
Some weak
channels may be
included or omitted
during this
procedure. You can
add or delete any
channels for
scanning in the
Channel Summary.
Noise Muting will
not work while you
operate the
Channel Summary.