Table of Contents
Advertisement
Maintenance Instructions
NOTE: Make sure the batteries
have been removed from the tool
before performing maintenance.
1.
Tool maintenance must be performed
only by qualified repair personnel.
Maintenance performed by unqualified
repair personnel could cause injury.
2.
When maintaining, use only identical
replacement components.
3.
Do not
attempt to take any pieces of the
tool apart unless directed by the manual.
4.
Follow instructions to
replace accessories.
Troubleshooting
SYMPTOMS
Display unit is on, but does
not show image.
LEDs on imager head are dim at max
brightness, display changes between
black/white and color, or display
turns itself OFF after a short period.
The tool will not turn on.
Page 10
Cable connection is loose.
Imager head is covered
with debris.
Batteries are low.
Dead batteries.
For technical questions, please call 1-888-866-5797.
5.
Do not
tool. Instead, use alcohol. Avoid
rubbing too hard on the LCD screen.
After using, wipe the display unit
clean gently with a dry cloth.
6.
Upon completion of any maintenance of
the tool, ask qualified repair personnel
to perform safety check to see if the
tool is in proper operating condition.
7.
Stop using the tool if it starts smoking
or emitting noxious fumes.
8.
Always handle the tool with care. It
is not shock-resistant and should
not be banged or dropped.
9.
Do not disassemble the tool beyond
what is shown in the manual.
Doing so will void your warranty.
POSSIBLE REASONS
use acetone to clean the
SOLUTIONS
Check and reattach.
Inspect imager head
and clean if needed.
Replace batteries.
Replace batteries.
Item 67979
Hide quick links:
Advertisement
Table of Contents
