Whirlpool ET20NK Use & Care Manual page 7

Changing the light bulbs...
1.
Reach behind the control console to find bulbs.
2. Remove bulb.
3. Replace with a 40.watt appliance bulb.
Removing the base grille...
To remove the grille:
r
METAL CLIPS
7
1. Open the door
To replace the grille:
2. Pull grille outwards as shown.
1.
Line up grille support tabs with metal clips.
3.
Do not remove Tech Sheet
fastened behinc!
2. Push firmly to snap into place.
grille.
3.
Close the door.
Ice cube trays...
It cubes are not used.they may shrink The mov-
1'19 cold air starts a slow evaporation. The longer
c.Abes are stored, the smaller they get.
To remove ice:
1.
Hold tray at both ends.
2. Slightly twist.
Optional automatic ice maker...
It you have the automatic ice maker accessory,
GI If you plan to add one luter (Part No ECKMF-83)
there are a few things you will want to know
* The ON/OFF lever is a wire signal arm
Down...for making Ice automatically
lip...to shut off the Ice maker.
DO NOT TURN ICE MAKER ON UNTIL IT IS CON-
NECTED TO THE WATER SUPPLY.
* !ne dial or lever on the side of the Ice maker
changes the size ot the cubes.
* Shakethe bin occasionally to keep cubes sepa-
r.lted,and toobtain Increased storage capacity
l
It IS normal for Ice crescents to be attached by a
~rner They will break apart easily
6
p-c-,
Off
LOWER SIGNAL
ARM TO START IT
di
I
RAISE SIGNAL
ARM TO STOP ICE
L
-
vOCr
will hear water running when Ice maker IS
tiorking You I heo: Ice fall lntn the b,r- Don't ie!
'.".;e s(-,J7(-4: *, -+c. .P '_
l
The Ice maker WIII not operate until the freezer
1s cold enough to make ice. This can take
overnight.
* Because of new plumbing connections, the first
Ice may be discolored or off-flavored. Discard
the first few batches of ice.
l
If ice is not being made fast enough and more
(ce
IS
needed, turn the Refrigerator Control to-
tiard a higher number. Wait a day and, if neces-
sary, turn the Freezer Control toward A
If you remove the ice bin, raise the signal arm to
shut off the ice maker. When you return the bin,
push it all the way in and lower the arm to the ON
posltion.
If cubes are stored too long, they may develop
an off-flavor ..like stale water. Throw them away.
They will be replaced. Cubes in the ice bin can
nls~ become smaller by evaporation
Good water quality is important for good ice
quality It IS not recommended that the ice maker
be connected to a softened water supply. Water
boftener chemicals such as salt from a malfunc-
+loning softener can damage the ice maker
mold and lead to poor quality ice. If a softened
water supply cannot be avoided, then it is impor-
-ail+ that the water softener be well maintained
operr!ting properI\
7