Nesco NC-5780 OURANO User Manual page 10

11. Do not fill kettle when positioned on base, Dry the water on the bottom of the
body before place it onto power base.
12. Never leave the appliance unattended when in use.
13. Do not use the kettle to heat anything other than water.
14. If the power cord is damaged, it must be changed by manufacturer or
authorized persons.
15. To prolong the kettle's life, please do not refill the kettle with water
immediately when the kettle is hot, please let the kettle cool down before re-use
or cleaning. Please clean the mineral deposits in the kettle regularly. Do not use
chemic matter to clean the surface of the kettle
16. This appliance is designed for domestic use only and not for commercial
applications.
OPERATING INSTRUCTION
For the first time to use or no use for a long time , we recommend that you fill to
the maximum level mark with fresh tap water , boil and empty the kettle then
wash it with water , repeat the operations above at least 2 times.
1. Pull out the power cord frome the compartment of the base unit, connect the
plug into a power outlet.
2. Open the lid then fill the water into the kettle.
3. Never allow the water above the maximum level or lower than the minimum
level.
4. Close the lid and lock it fully. Place exactly the kettle back on the base unit.
5. Switch the kettle on by pressing the switch at "I" position the light will illuminate
to indicate the kettle is heating.
6. The kettle will automatically switch off at "O" position once the water has
boiled and the neon light goes off. NOTE: If you need heat the water again
should switch it on after 30-60 seconds.
7. Lift the kettle frome the base by handle and pour out the water into cantainer.
NOTE : The switch just can work when the kettle body place exactly on the base
unit.
9