1.2 Cabling
Plug one end of the RJ11 cable into the ADSL port on the rear
panel of the Router and insert the other end into splitter , then
connect to Rj45 ports by an Ethernet cable your PCs or Switch.
Finally connect the Adapter to power inlet and turn the power
switch on. Now the I-Storm LAN Router ADSL will enter a self-
test phase for about ten seconds. After this phase the SYS led will
be flashed to indicate that router is in normal operation. Now you
should see the ADSL led first blinking during alignment and then
steady when connection is on.
1.3 The Front Panel LEDs
Port
6
POWER
7
SYS
8
USB
9-12
LAN
I-Storm LAN Router ADSL
Lit green when power adapter is connected.
System status indicators when blinking indicate
system is alive.
Steady
green
light
connection.
Blinking green light indicates an active WAN
session.
Information
indicates
a valid
ADSL
4