Table of Contents
Advertisement
Installing USB Video Streaming driver for Windows
When you connect the camcorder to the PC, four drivers are installed in succession by following the
procedures below.
NOTES:
Click [Continue Anyway] when the message [Has not passed Windows Logo testing] appears. Be sure not
to select [Stop Installation]. If you do so, the USB Video Streaming drivers will not be installed correctly.
1
Connect the camcorder to the PC with a USB cable.
After a moment, the [Found New Hardware Wizard] screen appears.
Refer to "Connecting the USB cable" (
2
Click [Install from a list or specific location (Advanced)] and then click [Next].
The driver search screen appears.
3
Click the next three items in the order below.
[Search for the best driver in these location]
[Include this location in the search]
[Browse]
4
Double-click [My Computer] on the desktop.
5
Double-click the CD-ROM drive icon and the [XP] folder, and then click [OK].
6
Click [Next].
The warning message dialog box appears.
7
Click [Continue Anyway].
After a moment, the [Found New Hardware Wizard] screen appears.
8
Click [Finish].
After a moment, the [Found New Hardware Wizard] screen appears again.
9
Repeat steps 2 to 8 until the [Found New Hardware Wizard] screen is cleared.
After you repeat steps 2 to 8 four times, the installation of the USB Video Streaming driver is complete.
Updating [Device Manager] (Windows
If the camcorder is connected to the PC with the USB cable before installing [USB Mass Storage Class driver]
or [USB Video Streaming driver], the installation might not be performed properly.
In this case, follow the procedure described below to update the [Device Manager] and install [USB Mass
Storage Class driver] and [USB Video Streaming driver] properly.
NOTE:
Disconnect any other USB audio devices from PC before performing the following procedure.
Installing [USB Mass Storage Class driver] (Windows
1
Use the USB cable to connect the camcorder to the PC. (
2
Select [Start] – [Settings] – [Control Panel]. Double click the [System] icon.
3
Select the [Device Manager] tab.
4
Delete [GR-DVP9*] in [Other devices].
* The model name depends on the connected camcorder.
5
Disconnect the USB cable from the camcorder. Restart the PC.
®
XP users
pg. 9).
®
)
®
98/98SE only)
— 8 —
pg. 9)
CONTINUED ON NEXT PAGE
Advertisement
Table of Contents
