Battery Information; Cleaning Your Pager; Repair And Maintenance - Motorola Advisor II User Manual

Alphanumeric and Long Numeric Missing Frag-
ment Indicators: If part of the message has not been
received, <...> or is displayed. Note: This applies
- - - - -
to ADVISOR II FLX pagers only.
Maildrop History: When this option is enabled, the
pager stores up to five history files per maildrop (infor-
mation services) slot selected. When a new maildrop
message is received on a specific slot, the existing
message is "pushed" into the history area and the new
message is stored in the maildrop slot. When a sixth
history file is received, the oldest history file is deleted.

Battery Information

Your pager is designed to operate with a single
alkaline battery (carbon zinc batteries are not recom-
mended). See the diagram on the following page for the
battery door location.
To install or replace the battery, place the pager face
down and proceed as follows:
? Loosen the battery door screw.
1
? Slide the battery door in the direction of the arrow
2
(toward the outer edge). Use the coin slot to assist
with the sliding of the battery cover.
? Lift the battery door away from the housing to
3
remove it. Lift the battery out of the battery compart-
ment, taking note of the positive (+) and negative (-)
markings on the battery and the pager housing.

Repair and Maintenance

Your pager, properly handled, is capable of many
years of trouble-free service.
However, if your pager ever requires ser vice,
Motorola's Service Organization, staffed with specially
trained technicians, offers conveniently located repair
and maintenance facilities throughout the world.
Please contact your paging service representative or a
Motorola sales office for more information.
-size
AA
15
17
Coin Slot
Screw
ADVISOR II Pager Battery
Replacement (rear view)
To install a new battery, reverse this procedure, taking
note of the positive (+) and negative (-) markings.
CAUTION: Do not insert the battery backwards or the
messages stored or locked in memory will be erased.
Care of Your Pager
To maintain the fine optical quality of the display in the
pager, do not subject it to extreme temperatures and
moisture.

Cleaning Your Pager

To clean smudges and grime from the exterior of the
housing, use a soft, nonabrasive cloth moistened in a mild
soap and water solution. Rinse the surface using a sec-
ond cloth moistened in clean water. Do not immerse the
pager in water. Do not use any other cleaning solu-
tions.
16
MOTOROLA, MOTO, MOTOROLA SOLUTIONS and
the Stylized M Logo are trademarks or registered trademarks
of Motorola Trademark Holdings, LLC and are used under license.
All other trademarks are the property of their respective owners.
© 2014 Motorola Solutions, Inc. All rights reserved.
Customer Care Services
1303 E. Algonquin Road,
Schaumburg, IL 60196 USA.
*688030964*
6880309P64-P
Programming
Connector Cover
(needs to be removed
for programming)