Clock Setup - Pittsburgh 93983 Owner's Manual & Safety Instructions

Clock Setup

(Standby mode)
The display will go to standby
Note:
mode and show the current time and room
temperature after use if the clock is set.
If the clock is not set, the display will shut
off after use, conserving battery power.
1. Press "Meas.".
2. Press "Mode" six times and the "Set" icon
starts to flash, indicating setup mode.
Temperature Unit Setup
1. Press "Meas." once to turn the unit on.
2. Press "Mode" five times and
the temperature unit icon starts
to flash (either °C or °F).
3. Press "Meas." to toggle the
unit between °C and °F.
4. Press "Mode" when complete.
Page 4
<->
(Power on)
For technical questions, please call 1-888-866-5797.
(12/24-hour setting screen)
3. Press "Meas." to make the "24" icon flash,
which indicates the 12/24-hour setting
screen.
Press "Meas." again to set 12/24-hour
Format from 24-hour to 12-hour.
4. Press "Mode" to switch to hour
setting. Use "Meas." to change it.
5. Press "Mode" to switch to minute setting
mode. Use "Meas." to change it.
6. Press "Mode" when complete.
7. To disable standby mode and enable the
automatic shutoff, remove the battery
for at least a minute and do not set
the clock after replacing the battery.
<->
Item 93983