4-2
Adding the IR Blaster Option
Installing the IR Blaster
To install the IR Blaster:
Fit the transmitter into the mounting bracket (refer to Figure 4-1).
1
Plug the mini-phone connector into the
2
(refer to Figure 4-2).
Figure 4-2
IR Blaster installed
DCT2500
RF IN
TO
TV/VCR
VCR
Remove the adhesive tape cover from the mounting bracket.
3
Position the IR receiver off center of the VCR receiver and then press firmly attaching the
4
mounting bracket on the VCR. Be careful to route the wire so that it does not prevent
loading videotapes.
Checking the Installation
The IR Blaster is now located near the receiver and the VCR can be controlled through the
DCT2500. As a final check, operate the VCR using the remote control from various positions in
the room. If the IR Blaster is obstructing the IR receiver on the VCR, move it slightly.
DCT2500 Installation Manual
jack on the rear panel of the DCT2500 rear panel
IR
R
L
TO TV
TO
AUDIO
RF IN
OUT
DIGITAL
AUDIO
TO VCR
OPTICAL
CABLE
IN
VIDEO
DIGITAL
S-VIDEO
AUDIO
COAX
PHONE
DATA
IR
USB
TV PASS CARD
SWITCHED
105-125V
60Hz
4A MAX
500W MAX