Triumph Trophy SE Handbook page 46

Bluetooth
ENTER PIN
UNPAIR ALL
Enter Pin Screen
The display will either show DEVICE 2
PAIRED if pairing was successful, or PAIRING
FAILED if pairing was unsuccessful.
HEADSET 1
DEVICE 2
PAIRED
UNPAIR ALL
Device Paired
If pairing fails, check that any PIN number
used is correct, the device is still in range, and
that the device is not requesting any
confirmation from you before it allows
connection to the motorcycle.
46
Un-pairing
Note:
• Un-pairing is similar for mobile
phones and
following
un-pairing a typical mobile phone
stored as DEVICE 2.
To access the BLUETOOTH menu;
1. With the motorcycle stationary, press and
hold the MODE/MENU button on the
audio switch
SETTINGS is highlighted in the display
screen.
2. Press and release the SCROLL button
until BLUETOOTH is highlighted. Press
the SELECT button to enter the menu
item.
10:08
AUDIO SETTINGS
AUDIO SETUP
SOURCE SETUP
BLUETOOTH
Bluetooth Setup Screen
Press the SCROLL button up or down and
select DEVICE 2 and press the SELECT
button.
If no device is paired the display will show
DEVICE 2 - PAIR.
To pair a device see page 44.
headsets.
procedure describes
unit until RADIO
N
22°C
EXIT
The