JVC KS-FX90 Instructions Manual page 35

KS-FX901/KS-FX801
Installation/Connection Manual
!"#$
GET0016-002A
[U]
ENGLISH
• This unit is designed to operate on 12 volts DC, NEGATIVE
ground electrical systems.
INSTALLATION (IN-DASH
MOUNTING)
• The following illustration shows a typical installation. However,
you should make adjustments corresponding to your specific
car. If you have any questions or require information regarding
installation kits, consult your JVC car audio dealer or a
company supplying kits.
1
Before mounting: Press (Control Panel Release button)
to detach the control panel if already attached.
* When shipped from the factory, the control panel is packed
in the hard case.
2
Remove the trim plate.
3
Remove the sleeve after disengaging the sleeve locks.
1 Stand the unit.
Note: When you stand the unit, be careful not to damage
the fuse on the rear.
2 Insert the 2 handles between the unit and the sleeve, as
illustrated, to disengage the sleeve locks.
3 Remove the sleeve.
Note: Be sure to keep the handles for future use after
installing the unit.
4
Install the sleeve into the dashboard.
* After the sleeve is correctly installed into the dashboard,
bend the appropriate tabs to hold the sleeve firmly in place,
as illustrated.
5
Fix the mounting bolt to the rear of the unit's body and place
the rubber cushion over the end of the bolt.
6
Do the required electrical connections explained on the back
of this instructions.
7
Slide the unit into the sleeve until it is locked.
8
Attach the trim plate so that the projection on the trim plate is
fixed to the left side of the unit.
9
Attach the control panel.
1
3
Handle
!"
Lock Plate
Slot
Fuse
10
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• Unit becomes hot.
* Is the speaker output lead grounded?
* Are the "–" terminals of L and R speakers grounded in common?
• !"#$% 12V
•
!"#$%
!"#$%&' ()*+,-./0123452
• •
!"#$%&'( )*+,-&./0!123.
!"#$%&'( JVC
!"#
1
!"
!"#$%
!"#$%&'()*+,&-./012
*
2
!"#
3
!"#$%&'()&*+
!"#
1
!"#$%&'()*+,-./01
!"#$%&'(%)*+,-./0123
2
!"
!"#$
3
!"#$%&'()*+,#-./0123
4
!"#$%&'()
!"#$%&'()*+,-./01-23!"45
*
!"#$%&'()*+
5
!"# $%&&'()* +,-./0$
!
6
!"#$%&'()%*+,-./01
7
!"#$ %&'(
8
!"
9 !"#
2
Sleeve
!
!
!"#
•
!"#$%&'!"#$%()*$+
*
!"#$
•
!"#$%&'$
*
!" #$
•
!"#$%&'()*+
*
!"
•
!"#$%&'()
*
!"#$ L
*
?
!"
•
!"#$%&'()
*
!"#$ L
*
?
!"#$%&'(
!
!"#$%&'()*
!"#$%&'()* !"#$
!"
!"
!"#$%& !"#$
Rubber cushion
Sleeve
!
7
8
9
Trim plate
?
?
?
?
!" – !
R
?
!" – !
R
JVC
Dashboard
!"
4
5
Mounting bolt
!
6
4
*
See "ELECTRICAL
CONNECTIONS."
"
R L
R L
0101HISFLEJES
V
J C
EN, CH, AR
•
DC
•
*
*
!"#
"
•
*
•
*
•
*
•
*
*
•
*
*