LG 55LW9500 Service Manual page 13

4.3.7. ALELF & EDGE LED White banlance table
- ALELF&EDGE LED module change color coordinate
because of aging time.
- Apply under the color coordinate table, for compensated
aging time.
- ALEF - LGD Only
Aging Time
GP3 (Min.) X
269
1 0-2 282
2 3-5 281
3 6-9 280
4 10-19 279
5 20-35 277
6 36-49 274
7 50-79 271
8 80-149 270
9 Over 150 269
4.4. Wireless function check
Step 1) Connect set and Dongle of Wireless to Cable of HDMI
& TTA 20Pin.
Step 2) At OSD of SET, check the message like Fig 3.
Step 3) Detach Cable of Wireless Dongle.
Fig.1
Fig.3 Connect the Dongle
Copyright © 2011 LG Electronics. Inc. All rights reserved.
Only for training and service purposes
Cool Medium
Y X Y
273 285 293
294 298 314
292 297 312
291 296 311
289 295 309
284 293 304
279 290 299
277 287 297
274 286 294
273 285 293
Connect
Fig.2
4.5. EYE-Q function check
Step 1) Turn on TV.
Step 2) Press EYE key of Adjustment remote control.
Step 3) Cover the Eye Q II sensor on the front of the using
Step 4) Confirm that R/G/B value is lower than 10 of the "Raw
Warm
X Y
313 329
Step 5) Remove your hand from the Eye Q II sensor and wait
322 343
321 341
Step 6) Confirm that "ok" pop up. If change is not seen,
320 340
319 338
317 333
314 328
311 326
310 323
309 322
4.6. Local Dimming Function Check
Step 1) Turn on TV.
Step 2) At the Local Dimming mode, module Edge Backlight
Step 3) Confirm the Local Dimming mode.
Step 4) Press "exit" key.
4.7. Magic Motion Remote control test
- Equipment : RF Remote control for test, IR-KEY-Code
Remote control for test
- You must confirm the battery power of RF-Remote control
before test(recommend that change the battery per every lot)
- Sequence (test)
1) if you select the 'start(Mute)' key on the controller, you
can pairing with the TV SET.
2) You can check the cursor on the TV Screen, when select
the 'OK' key on the controller.
3) You must remove the pairing with the TV Set by select
'OK' Key + 'Mute' key on the controller for 5 seconds.
- 13 -
your hand and wait for 6 seconds.
Data (Sensor data, Back light)". If after 6 seconds,
R/G/B value is not lower than 10, replace Eye Q II
sensor.
for 6 seconds.
replace Eye Q II sensor.
moving right to left Back light of IOP module moving.
Local Dimming Demo (Edge LED Model)
Local Dimming Demo (IOP & ALEF Model)
LGE Internal Use Only