Sony DAV-SR4W Owner's Manual page 29

Hanging the IR transmitter and IR receiver on a wall
You can hang the IR transmitter and IR receiver on a wall when:
– there is an obstruction between the IR transmitter and the IR receiver.
– people often pass between the IR transmitter and the IR receiver.
When hanging both the IR transmitter and IR receiver, adjust the position of the IR transmitter after
deciding the position of the IR receiver.
To hang the IR receiver on a wall
1
Install a commercially available screw
in the wall so that it protrudes 4 mm.
4 mm
2
Detach the IR receiver stand and hang
it via hole on the rear side of the IR
receiver on the screw.
Make sure that the IR receiver does not
move after installation.
IR receiver
IR receiver stand
Tip
When reattaching the IR receiver stand to the IR
receiver, attach the stand so that both delta marks on
the IR receiver and stand are aligned (page 13).
To hang the IR transmitter on a
wall
1
Rotate the stand of the IR transmitter.
IR transmitter
Stand
2
Install 2 commercially available screws
in the wall so that it protrudes 4 mm.
Install the screws 30 mm apart.
30 mm
4 mm
continued
29 GB