Bypass Mode; Noise Gate - dbx 290 Operation Manual

• • •
Operation
To place the 290's reverb into Bypass mode, press and hold the [ROOM]
and [CHAMBER] reverb Type buttons simultaneously. Bypass mode is
indicated by the flashing LEDs of the currently selected Type/Size /Color
buttons. Pressing any button will exit the Bypass mode (along with
changing the setting if a new Type/Size /Color is selecte d). An external
footswitch can also be used to enter or exit the Bypass mode.
NOTE: Bypass mode affects only the wet portion of the Wet/Dry signal
(this means that Bypass acts as a reverb mute).
-----*-----
The dbx 290 includes a digital noise gate to push the noise floor down,
ensuring that the 290 is at its quietest when sitting idle (the most impor ­
tant time to be quiet). The noise gate is located just before the 290's
reverb, which the means reverb's decay never gets prematurely cut off.
Threshold is the one parameter that may need adjustment in your partic­
ular application. This is the level at which the gate will open. Threshold
. . MAU CMA8lR ....11 CAT.. DMl
una
IIIAU .DIUII
LM.
IT][TI
OJ OJ LJ LJ CJ LJ CJ
. -
-
­
..-=:IlllI/un
'*"
e:::-­
• • •
"PI
•
,
Level 3 (highest threshold)
, ,
9
Lavel2
0 0
Lavell
• •
,
, ,
•
0 0 0 Lavel 0 (off)
is set by doing the following:
• Simultaneously press and hold the [SMALL] and [LARGE] Size but­
tons until their respective LEDs light.
• The current threshold setting is displayed using the reverb Type
LEDs in the following manner:
• To choose a new Threshold setting, Simply select one of the first
four Type buttons for the desired level.
The 290 pauses briefly to show your selection and then returns to
normal operation mode.
The purpose of the noise gate is to eliminate unwanted noise in the
absence of program material at the 290's inputs. Unwanted noise usually
comes from other not-so-quiet pieces of equipment. By using the gate,
Bypass Mode
Noise Gate
Stereo
-
ReverbJ lJIJe
. . . . 9