Programming Methods; Feature Select Programming; Decimal Programming; Module Broadcast - Paradox DGP2-641 Reference And Installation Manual

3.2 PROGRAMMING METHODS

The following methods can be used when programming the keypad:
3.2.1 F
EATURE
Some sections are programmed by enabling or disabling
options. Within the sections, numbers from [1] to [8] represent
a specific keypad option. Press the key corresponding to the
desired option and the digit will appear in the display. This
means the option is enabled. Press the key again to remove
the digit from the display thereby disabling the option. Press
[ ] when options are set.
ENTER
3.2.2 D
ECIMAL
Some sections require that a decimal value be entered. In this
method, any digit from 000 to 255 can be entered.

3.3 MODULE BROADCAST

The control panel's Module Broadcast feature can be used to copy
the contents of one keypad to one or many other keypads.
Step 1: From Normal Mode press and hold the [0] key.
Step 2: Enter [
Step 3: Enter section [954] (DGP-48) / [4004] (DGP-NE96).
Step 4: Enter the [
programmed keypad whose data you want to copy to other
keypads.
Step 5: Enter the [
destination is the keypad(s) you want to program with the
source's data. If you want to program more than one keypad
with the source's data, enter the serial numbers of the
keypads one at a time.
Step 6: Once you have entered the serial numbers of the keypads
you want to program, press the [
S P
ELECT ROGRAMMING
P
ROGRAMMING
INSTALLER CODE
#] of the source keypad. The source is the
SERIAL
SERIAL
] (default: 000000).
#] of the destination keypads. The
ACC
Digiplex/DigiplexNE LCD Keypad
] key.
13n