Philips 46HFL5784L Quick Start Setup Manual page 11

Installation of pay-per-view box
This section describes how to install a external pay-per-
view box.
Step 1 : Set the communication mode
You must setup the correct communication protocol before
you connect the Pay-per-View box to the TV. This section
describes how to select the communication mode.
1
Press MENU on the setup remote control to display the
setup menu.
2
Select SPI and the appropriate option (3v3 , 5v).
Step 2 : Set the communication mode
Note
•
Turn off your TV before you connect the pay-per-view box.
1
Insert the RJ12 cable of the Pay-per-View box into the
RJ12 connector of the TV.
2
Connect the other cables as directed by the Pay-per-
View provider.
3
After completing the connections of the cable, turn on
the TV.
4
Press RECALL on the setup remote control and check
that the status of SPI ONLINE in page 4.
Multi RC
Multi RC enables control of multiple TVs in a room without
any interference from each other's remote control.
To enable Multi RC, each remote control is set to one of
the four colors - Blue, Green, Yellow or Red. Each TV in the
room is separately programmed to a remote control of
one of those colors. In this way, each TV responds to only
one RC that is set to the same color as the TV itself. This
prevents interference from each other's remote control
when you watch multiple TVs in a room.
1
Press MENU on the setup remote control to display
the setup menu.
2
Select System.
3
Select MultiRC and the correct color code.
4
Press ÎïÍÆ to select [Select a color code].
•
The TV is configured to respond to the RC that is set to the
same color.
5
On the guest RC, press HOME (the menu button) and
the color button (same color as above) simultaneously,
for at least 5 seconds.
•
The guest RC is set to the selected color.
Note
•
The Guest RC defaults to Blue, and a remote which has been
set to any color can operate any TV which has not been
confi gured to a different color yet. Therefore, if 2 TVs are being
confi gured in the same space, then each TV/RC pair MUST
be set a their own color (one pair cannot be left as default,
otherwise both RCs will operate the TV which has not been
confi gured).
Watch your video on a USB storage
device
1
Connect your USB storage device to the TV.
2
Press MENU on the remote control to display the guest
menu.
3
Select Browse USB.
11