Compliance And Safety Information; General Warnings, Regulatory And Safety - Cisco Flex 7500 Series Installation Manual

Compliance and Safety Information

Compliance and Safety Information
FCC Safety Compliance Statement
Modifying the equipment without Cisco's authorization may result in the equipment no longer
complying with FCC requirements for Class A digital devices. In that event, your right to use the
equipment may be limited by FCC regulations, and you may be required to correct any interference to
radio or television communications at your own expense.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case users will be
required to correct the interference at their own expense.
Try to correct the interference by one or more of the following measures:
•
•
•

General Warnings, Regulatory and Safety

Conventions
Safety warnings appear throughout this guide in procedures that may harm you if performed incorrectly.
A warning symbol precedes each warning statement. Specific warnings are included in the sections to
which they apply.
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071 SAVE THESE INSTRUCTIONS
Means reader be careful. In this situation, you might do something that could result in equipment damage
Caution
or loss of data.
Cisco Flex 7500 Series Wireless Controller Installation Guide
1-4
Verify that the ambient temperature remains between 50 to 95° F (10 to 35° C), taking into account
the elevated temperatures when installed in a rack or enclosed space.
When multiple Cisco Flex 7500 Series Wireless Controllers are mounted in an equipment rack, be
sure that the power source is sufficiently rated to safely run all the equipment in the rack.
Verify the integrity of the electrical ground before installing the controller.
Chapter 1 Cisco Flex 7500 Series Wireless Controller Installation Guide