Dubbing To Or From A Video Unit Equipped With A Dv Connector - JVC MINI DV NTCS GR-DVL100 Instructions Manual

Connector cover
To DV
IN/OUT
Core filter
DV cable
(optional)
Core filter
To DV
IN/OUT
Video unit equipped
with DV connector
PLAY (4)
STOP (5)
To Use This Camcorder As A Recorder . . .
1. Turn the Power Switch to "
2. Set "REC MODE" to "SP" or "LP" in the Menu Screen (
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press the Recording Start/Stop button to engage the Record-Pause mode. "DV. IN" appears on the screen.
5. Press the Recording Start/Stop button to start recording. "DV. IN" changes to "
6. Press the Recording Start/Stop button again to engage the Record-Pause mode. "
"DV. IN".
NOTES:
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
"SOUND MODE" setting (
During Digital Dubbing, no signals are output from the video or audio connectors.
Dubbing To Or From A Video Unit Equipped
With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
[To use this camcorder as a player]
Power Switch
1
2
3
4
NOTES:
It is recommended to use the AC Power Adapter/Charger
as the power supply instead of the battery pack (
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press
the buttons on both units.
For Digital Dubbing, this camcorder can be connected
only to one device at a time. This camcorder can also be
used as a recorder.
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If this
occurs, turn off the power and make connections again.
If "Playback Zoom" (
attempted during playback, only the original playback
image recorded on the tape is output from the DV IN/
OUT connector.
When using a DV cable, be sure it has a core filter
attached. The core filter reduces interference.
" while pressing down the Lock Button located on the switch.
pg. 23).
Make sure the camcorder's power is off.
Connect the camcorder to your video unit equipped
with a DV connector using a DV cable as shown in
the illustration.
Press 4 to play back the source tape.
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
pg. 42) or "Snapshot" is
pg. 32)
39
EN
pg. 9).
".
DV. IN
" returns to
DV. IN