Reset Feature; Co Peak Level Memory - Kidde KN-COSM-IBACA (900-0119) User Manual

Operating and Installation Instructions
Your Smoke/CO Alarm will automatically reset after
approximately 9 minutes. When the unit returns to normal
operation after being in HUSH mode, it will verbally announce
"HUSH MODE CANCELLED", and sound the alarm if smoke is
still present. The HUSH feature can be used repeatedly until the
air has been cleared of the condition causing the alarm. While
the unit is in HUSH mode, pushing the test/reset button on the
alarm will also end the HUSH period.
®
NOTE: DENSE SMOKE WILL OVERRIDE THE HUSH
CONTROL FEATURE AND SOUND A CONTINUOUS
ALARM.
®
!
CAUTION: BEFORE USING THE ALARM HUSH
FEATURE, IDENTIFY THE SOURCE OF THE SMOKE AND
BE CERTAIN A SAFE CONDITION EXISTS.

Reset Feature

If the the Smoke/CO Alarm is sounding a CO alarm, pressing
the test/reset button will silence the alarm.
If the CO condition that caused the alert continues, the alarm
will reactivate within 200 seconds.

CO Peak Level Memory

If the green LED is blinking once every 10 seconds, the unit has
detected a hazardous CO condition. If the CO sensor has
detected a CO level of 100 PPM or higher since last reset, it will
be recorded by the Peak Level Memory function. To access the
Peak Level Memory press the test/reset button. If a reading of
100 PPM or higher has been recorded, the unit will announce
"Carbon Monoxide Previously Detected." If you've been away
from home this feature allows you to check if there was a CO
reading of 100, or higher, during your absence. Pushing the
test/reset button resets the memory. It's also reset when the
power is removed.
Note: When the unit is on battery power only, the green LED will
not blink to indicate CO Peak Level Memory.
17