Table of Contents
Advertisement
)
)
How to Label Hubs
You should label all Hubs
in
a StarLAN 10 Network to simplify the
tasks of administration and troubleshooting.
The Hub to which all other Hubs in a room or wiring closet are
connected is called a primary Hub. All Hubs connected to a
primary Hub within the same room or wiring closet are called
secondary Hubs.
~
Note
The StarLAN 10 Network Hub Unit Design Form, included
in
the
"Before You Install a Hub" section of this guide, should be
maintained to identify the destination of each connection to the
Hub.....
To label one or more Hubs in a room or a wiring closet, follow
these steps:
1 Label the primary Hub (to which all other Hubs in the room or
wiring closet will be connected) as "Hub I."
2 Label all secondary Hubs in the room or wiring closet as "Hub
2" with extensions in sequential order. For example, the first
secondary Hub should be labeled "Hub 2-1 " the second
secondary Hub should be labeled "Hub 2-2," etc., as shown in
Figure 16.
Hub Placement
45
Advertisement
Table of Contents
