Table of Contents
Advertisement
P. STABILIZER
RETAKE (R/F)
FEATURE:
Quick Review
PURPOSE:
To check the end of the last
recording.
OPERATION:
1) Press "
during the Record-Standby mode.
Tape is rewound for about 2
seconds and played back
automatically, then pauses in
Record-Standby mode for the
next shot.
NOTE:
Distortion may occur at start of
playback. This is normal.
FEATURE:
Retake
PURPOSE:
To re-record certain segments.
OPERATION:
1) Make sure the camcorder is in the
Record-Standby mode.
2) Press either RETAKE button to
reach the start point for new
recording. Pressing "F" forwards
the tape and pressing "R" reverses
it.
3) Press Recording Start/Stop Button
to start recording.
Noise may appear during Retake.
NOTE:
This is normal.
FEATURE:
Picture Stabiliser
PURPOSE:
To compensate for unstable images
caused by camera-shake, particularly
at high magnification.
OPERATION:
1) Press P. STABILIZER. "
To switch off the Picture
Stabiliser, press P. STABILIZER.
The indicator disappears.
NOTES:
Accurate stabilisation may not be
possible if hand shake is excessive,
or under the following conditions:
• When shooting subjects with
vertical or horizontal stripes.
• When shooting dark or dim
subjects.
• When shooting subjects with
excessive backlighting.
• When shooting scenes with
movement in various directions.
• When shooting scenes with low-
contrast backgrounds.
Switch off the Picture Stabiliser
when recording with the
camcorder on a tripod.
15
EN
" and release quickly
"appears.
Advertisement
Table of Contents
