Table of Contents
Advertisement
38
EN
REW/FF
STOP
PLAY/PAUSE
To AUDIO
and VIDEO
out connectors
Audio and
Video cable
(optional)
To AUDIO
and VIDEO IN
connectors
VCR (Recording deck)
IN
OUT
1
0:00:25
2
3
4
5
6
7
8
COUNTER
0:00:25
TOTAL
0:00:00
IN/OUT
CANCEL
R.A. EDIT
Open the cover
To J terminal
(JLIP)
Editing cable
(ø3.5 mini-plug
cable, provided)
A B
C
To Remote
PAUSE
To Pause-In
MBR
(provided)
IN/OUT
CANCEL
VCR REC STBY
ON/OFF
IN
OUT
1
0:00:25
0:01:05
2
0:03:18
0:03:31
3
0:02:33
0:02:53
4
0:04:11
5
6
7
8
COUNTER
0:04:11
TOTAL
0:01:13
PREPARE CAMCORDER
2
Insert a recorded tape and set the Power switch to
"PLAY".
PREPARE VCR
3
Turn the power on, insert a recordable tape and
engage the AUX mode (refer to VCR's instructions).
SELECT SCENES
ACCESS R.A. EDIT COUNTER
DISPLAY
1
Press PLAY/PAUSE, then press R.A. EDIT and the
counter display appears in the viewfinder and the
screen of the connected TV.
REGISTER BEGINNING OF SCENE
2
Press REW or FF to locate the beginning of a scene
you want, then press IN/OUT to register that point.
The data appears under IN on the display.
REGISTER END OF SCENE
3
Press REW or FF to locate the end of the scene and
press IN/OUT to register it. The data appears under
OUT on the display. The total time of the registered
scene(s) is displayed at the bottom of the screen.
REGISTER ADDITIONAL SCENES
4
Repeat steps 2 and 3 for each additional scene
(as many as 8).
MAKE CORRECTIONS
5
Press CANCEL during steps 2 and 3 to erase the
most recently registered point.
NOTES:
The MBR can be used to operate other camcorder
functions as well. Point the MBR at the camcorder's
remote sensor and press any of the following buttons
(function appears in parentheses):
— ON/OFF (camcorder R.A. EDIT)
— IN/OUT (camcorder IN/OUT)
— CANCEL (camcorder CANCEL)
There must be at least one second between an in-point
and its corresponding out-point.
To ensure correct operation, there should be at least
15 seconds between an out-point and the next in-point.
Blank portions of tape cannot be registered as in-points
or out-points.
If it takes more than 5 minutes to search for an in-point,
the VCR's Record-Pause mode is cancelled and editing
doesn't take place.
Pressing R.A.EDIT clears all in- and out-points from
memory.
Leave a small margin for error around each in-point to
ensure the scene is recorded in its entirety.
EDITING
(cont.)
Advertisement
Table of Contents
