Table of Contents
Advertisement
IDV33/IDV36 Riser Kit and Leveling Instructions
Leveling Instructions
When installing insert it may be necessary to support back of unit.
To support back of insert, there are two leveling plates right and
left of unit.
1. Measure height required to level unit.
2. Remove two [2] outer screws and loosen center screw holding
each plate into position.
3. Slide plates to the required height and align with appropriate
holes. Each set of holes equals to a 1/4" of movement up to a
maximum of four inches. Insert and tighten all screws (e.g. 1"
of movement equals to 4 holes).
Riser Kit Installation Instructions – Model No.: I33R40 / I33R44
1. Measure height required to make flush with base of unit, Fig. 1. If measurement equals to the height of riser kit 2.5"
skip to Step 3. No adjustment will be required.
2. Adjust leveling legs to required height in Step 1, Fig. 3 (Detail A).
3. Locate mounting holes punched into base right and left of unit. Place riser assembly under front of insert and fasten to
base with supplied screws, Fig. 2.
WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.
17
Advertisement
Table of Contents
