Error Codes Description; Troubleshooting / Resetting Error Codes - LifeGear 97320 Owner's Manual

Error codes description

The error codes "E1" or "E2" display on the electronic console which indicate the malfunction of
the motor controller during workout session and will have a series of continuous audible "beeps"
from the electronic console.
ERROR CODE DESCRIPTION
E1 Speed error (The treadmill running speed is 3.2 kph faster than the displayed
speed). The treadmill will stop immediately when the console detects this error.
E2 Speed error (The treadmill running speed is 3.2 kph slower than the displayed
speed). The treadmill will stop 16 seconds later after the console detects this
error.

Troubleshooting / Resetting error codes

In the rare event of the treadmill displaying an error code ("E" followed by a number), simply reset
the computer by:
1. Step off the treadmill. Ensure that you are clear of the running belt.
2. Turn the treadmill off at the master power switch located near the motor housing.
WARNING: Ensure nothing is positioned near or under running belt which may possibly block
it's normal operation.
3. Turn the treadmill on at the master power switch.
4. Ensure that the Safety Tether Key is securely and properly installed onto the console or just
reinstalling the Safety Tether Key can also reset the display.
If the above does not clear the error code, please contact the nearest Dealer/Service Center.
16