Page 1
INSTRUCTION MANUAL IMPORTANT INFORMATION : Please read these instructions carefully and make sure you understand them before using this unit. Retain these instructions for future reference. MANUEL D’INSTRUCTIONS RENSEIGNEMENTS IMPORTANTS: Avant d’utiliser cet appareil, veuillez lire atentivement les instructions et assurez- -vous de les avoir comprises. Conservez les instructions pour référence ultérieure.
KEY TO SYMBOLS WARNING: This blower Use unleaded or quality can be dangerous! Careless leaded petrol and two or improper use can stroke oil. cause serious or even fatal injury. WARNING: The blower may throw Read and understand the objects at high velocity that can instruction manual before ricochet and hit the operator.
Inspect unit before each use for worn, loose, only recommended Partner® missing, or damaged parts. Do not use until replacement parts; use of any other parts unit is in proper working order. may void your warranty and cause damage to Keep outside surfaces free of oil and fuel.
WHAT IS WHAT? WHAT IS WHAT? 1. Throttle trigger Upper blower tube 2. STOP switch 10. Lower blower tube 3. Primer button 11. High- -speed nozzle 4. Choke lever 12. Elbow tube 5. Fuel cap 13. Vacuum bag 6. Starter rope 14.
Page 5
NOTE: 2. Secure the tube by turning the bolt clock- Make sure edge of the small open- wise. ing is flush against the flared area of the el- 3. Align the slots on the lower blower tube bow tube, and the rib on the elbow tube is with the tabs on the upper blower tube.
HOW TO CONVERT UNIT FROM VACUUM USE TO BLOWER USE 1. Remove the elbow tube and vacuum bag by turning the knob counterclockwise to loosen the elbow tube. 2. Remove the vacuum tubes by turning the tubes clockwise. 3. Close the vacuum inlet cover and make sure it is latched closed.
This engine is certified to operate on unleaded petrol. Before operation, petrol must be mixed with a good quality 2-cycle air-cooled engine oil. We recommend Partner brand oil mixed at a ratio of 40:1 (2.5%). A 40:1 ratio is obtained by mixing 5 liters of unleaded petrol with 0,125 liter of oil.
gine doesn’t start after 6 pulls (at the HALF WARNING: CHOKE position), move the choke lever to When starting engine, the FULL CHOKE position and press the hold the unit as illustrated. Do not set unit on primer bulb 6 times. Squeeze and hold the any surface except a clean, hard area when throttle trigger and pull the starter rope 2 starting engine or while engine is running.
A dirty air filter decreases engine perform- ance and increases fuel consumption and harmful emissions. Always clean after every 5 hours of operation or yearly, whichever comes first. 1. Clean the cover and the area around it to keep debris from falling into the carburetor chamber when the cover is removed.
Idle Speed Screw If you require further assistance or are unsure about performing this procedure, contact an authorized service dealer. Filter Cover STORAGE INTERNAL ENGINE WARNING: Prepare unit for storage at S Remove spark plug and pour 1 teaspoon of end of season or if it will not be used for 30 days 2-cycle engine oil (air cooled) through the or more.
Page 11
TROUBLESHOOTING TABLE WARNING: Always stop unit and disconnect spark plug before performing any of the recommended remedies below other than remedies that require operation of the unit. TROUBLE CAUSE REMEDY Engine will not 1.Engine flooded. 1.See “Starting Instructions.” 2.Fuel tank empty. 2.Fill tank with correct fuel mixture.
We, Husqvarna Outdoor Products Italia, S.p.A., Valmadrera, Italy. Tel: +39- -0341- -203211, declare that the leaf blower model Partner GBV 325 from serial numbers 2007- -335N00001 and onwards (the year is clearly stated on the rating plate, followed by the serial number), comply with the requirements of the COUNCIL’S DIRECTIVES:...