Page 1
OPERATOR'S MANUAL Cat. No. M12 CPD 13 mm (1/2") M12™ FUEL™ HAMMER DRILL/DRIVER TO REDUCE THE RISK OF INJURY, USER MUST READ AND UNDERSTAND OPERATOR'S MANUAL.
GENERAL POWER TOOL SAFETY WARNINGS WARNING READ ALL SAFETY WARNINGS AND ALL INSTRUCTIONS. Save all warnings and instructions for future reference. WORK AREA SAFETY A wrench or a key left Cluttered or attached to a rotating part of the power tool may dark areas invite accidents.
These carry SERVICE important information. If unreadable or missing, contact a MILWAUKEE service facility for a replacement. This will ensure that the safety of the power Some dust created by power sanding, tool is maintained.
SPECIFICATIONS Capacities No Load No Load Cat. No. DC Steel 25.4mm 44.4mm 13mm 28.5mm 10mm 10mm M12 CPD LO 0-450 LO 6750 HI 0-1700 HI 25,500 (1") (1 3/4") (1/2") (1 1/8") (3/8") (3/8") FUNCTIONAL DESCRIPTION ASSEMBLY WARNING the battery, push in the release buttons and pull the battery pack away from the tool.
OPERATION WARNING mode, rotate the application selector collar until the hammer symbol appears in line with the arrow. Apply pressure to the bit to engage the hammering mechanism. WARNING The number selected on the torque selector collar has no effect on operation of the drill in hammer mode.
Page 7
The torque speci cations shown here are approximate 1. To the tool, grasp the handle rmly and pull values obtained with a fully charged battery pack. the trigger. NOTE: An LED is turned on when the trigger is pulled. 2. To the speed, increase or decrease the 5-15 Small screws in softwood.
If the tool still does not work Back the material to prevent binding and distortion properly, return the tool, charger and battery pack, on breakthrough. to a MILWAUKEE service facility for repairs. When drilling in masonry, select the hammer WARNING drill operating mode.
Page 9
ACCESSORIES WARNING For a complete listing of accessories, refer to your MILWAUKEE Electric Tool catalog or go online to www.milwaukeetools.com.au / www.milwaukeetools.co.nz. To obtain a catalog, contact your local distributor or service center.
Page 12
Techtronic Industries (Australia) Pty. Ltd. Doncaster, Victoria, Australia, 3108 Milwaukee Electric Tool Corporation (New Zealand) Techtronic Industries (New Zealand) Pty. Ltd. Mt Wellington, Auckland, New Zealand, 1060 Professionally made in China for Milwaukee Electric Tool Corporation 58-14-2380d1 Printed in China 961075205-01( )