Special Tools; For Tune Up; For Engine Service - Yamaha PZ50W Service Manual

SPECIAL TOOLS

SPECIAL TOOLS
Some special tools are necessary for a completely accurate tune-up and
assembly. Using the correct special tool will help prevent damage that can
be caused by the use of improper tools or improvised techniques.
NOTE:
• Be sure to use the correct part number when ordering the tool, since the
part number may differ according to country.
• For USA and Canada, use part number starting with "YB-", "YM-", "YU-"
or "YS-".
• For others, use part number starting with "90890-".

FOR TUNE UP

• Dial gauge
P/N: YU-03097
90890-03097
This gauge is used for run out measurement.
• Angle gauge
Use goods on the market.
This tool is used to tightening the torque.
• Steering linkage alignment plate
P/N: YS-01515
90890-01515
Locks steering relay arm and pivot arm shaft in place while adjusting the
steering linkage for front-end alignment.

FOR ENGINE SERVICE

• Piston pin puller
P/N: YU-01304
90890-01304
This tool is used to remove the piston pin.
• Rotor holding puller
P/N: YU-33270-B
90890-01362
• Flywheel puller attachment
P/N: YM-33282
90890-04089
These tools are used to remove the magneto rotor.
1-4
GEN
INFO