Electro-Voice X-Line Very Compact Rigging Manual page 7

Hoist Motor
Grid
Quick-Release Pin
Eight XLD281
Enclosures Hinged at the
Front by the Extended
Hinge Bars and Front
Rigging Tube Modules
Hinge Bar
XLD281 Enclosures
Typical XLVC Flying System (without Coupler Beam)
The swing arm from an enclosure below can be pivoted up so that the quick-release pin from the
enclosure below may be inserted through a hole in the rigging slot on the channel module above,
linking the two enclosures together. The vertical tilt angle of the bottom enclosure is then
determined by the hole in which the swing arm is pinned. The XLD281 and XLE181 enclosures
may be angled from 0° to 10° in 1° increments, while the XS212 enclosure may be angled from 0°
to 20° in 2° increments. The angle adjustment holes are detailed in figures 4a and 4b. This pin
fixes the maximum distance the back corners of the enclosures may be separated.
®
ELECTRO-VOICE X-Line Very Compact
Quick-
Release
Swing
Arm
Quick-
Release
Figure 2:
TM
Rigging Manual
Pin
Pin
Swing Arm
Angles Between
Enclosures fixed by Pins
through the Swing Arms
and Rear Rigging Holes
in the Channel Modules
Hoist Motor
Grid
Two XS212 Enclosures
Hinged at the Front by
the Extended Hinge Bars
and Rigging Tube
Quick-
Modules
Release Pin
Hinge Bar
XS212 Enclosures
6