Dubbing To Or From A Video Unit Equipped With A Dv Connector - JVC GR-DVM80 Instructions Manual

POWER Switch
Lock Button
To DV IN/OUT
To DV IN/OUT
To Use This Camcorder As A Recorder . . .
1. Turn the POWER Switch to "
2. Set "REC MODE" to "SP" or "LP" in the Menu Screen (
3. Connect the DV cable as shown in the illustration and load a cassette to record on.
4. Press START/STOP to engage the Record-Pause mode. "DV IN" appears on the screen.
5. Press START/STOP to start recording. "DV IN" changes to "
6. Press START/STOP again to engage the Record-Pause mode. "
NOTES:
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
"SOUND MODE" setting (
During Digital Dubbing, no signals are output from the AV OUT connector.
Open the
connector cover.
Core filter
DV cable
(optional)
Core filter
Video unit equipped
with DV connector
PLAY (4)
STOP (5)
" while pressing down the Lock Button located on the switch.
pg. 25).
Dubbing To Or From A Video Unit Equipped
With A DV Connector (Digital Dubbing)
It is also possible to copy recorded scenes from the
camcorder onto another video unit equipped with a DV
connector. Since a digital signal is sent, there is little if any
image or sound deterioration.
[To use this camcorder as a player]
1
Make sure the camcorder's power is off.
2
Connect the camcorder to your video unit equipped
with a DV connector using a DV cable as shown in
the illustration.
3
Press 4 to play back the source tape.
4
While watching the playback on the monitor, engage
the DV connector-equipped video unit's record mode
from the spot on the source tape you want to begin
recording.
NOTES:
It is recommended to use the AC Power Adapter/
Charger as the power supply instead of the battery pack
( pg. 9).
If the remote control is used when both the player and
recorder are JVC video units, both units will perform the
same operation. To prevent this from happening, press
the buttons on both units.
For Digital Dubbing, this camcorder can be connected
only to one device at a time. This camcorder can also be
used as a recorder.
If a blank portion or disturbed image is played back on
the player during dubbing, the dubbing may stop so that
an unusual image is not dubbed.
Even though the DV cable is connected correctly,
sometimes the image may not appear in step 3. If this
occurs, turn off the power and make connections again.
If "Playback Zoom" (
Effects" ( pg. 49) or "Snapshot" is attempted during
playback, only the original playback image recorded on
the tape is output from the DV IN/OUT connector.
When using a DV cable, be sure it has a core filter
attached. The core filter reduces interference.
pg. 37)
".
DV IN
" returns to "DV IN".
DV IN
EN
pg. 48), "Playback Special
45