Table of Contents
Advertisement
Switch this system to Assisted Wi-Fi
Setup mode
Note
‡
%HIRUH \RX SUHVV DQ\ EXWWRQ RQ WKH PDLQ XQLW PDNH
sure that the system has been booted up successfully
(see 'Turn on' on page 16).
Press WIFI SETUP on the top panel.
» The LED indicator in the middle of
WIFI SETUP button stays solid yellow.
» A new Wi-Fi network is created
DXWRPDWLFDOO\ ZLWK WKH QHWZRUN
name (SSID) of Philips DCW8010
XXXXXX.
» It takes up to 45 seconds for successful
creation of this new Wi-Fi network.
Note
‡
$IWHU \RX ÀQLVK WKH PDQXDO :L)L VHWWLQJ IRU WKLV V\VWHP
this new Wi-Fi network disappears.
‡
,I \RX IDLO WR HQWHU $VVLVWHG :L)L 6HWXS PRGH
UHFRQQHFW WKH SRZHU DGDSWRU DQG WKHQ WU\ DJDLQ DIWHU
successful boot-up.
‡
Make sure that no other Philips AirPlay-enabled devices
are in Assisted Wi-Fi Setup mode at the same time.
Multiple new Wi-Fi networks created this way may
interfere with each other.
‡
7R FKDQJH :L)L VHWXS DIWHU ÀUVWWLPH VHWXS SUHVV DQG
hold WIFI SETUP for more than 3 seconds to reset
Wi-Fi settings. Then follow the previous steps to change
your network settings.
Connect your Wi-Fi enabled device to
the newly created Wi-Fi network
The new Wi-Fi network created by this system
only allows access of one Wi-Fi enabled device.
To avoid interference from any other Wi-Fi
GHYLFH \RX DUH UHFRPPHQGHG WR WHPSRUDULO\
disable the Wi-Fi function on your other Wi-Fi
devices.
Option 1: Use your iPod touch/iPhone/iPad
20
EN
1
Select Settings (Settings) -> Wi-Fi (Wi-Fi)
on your iPod touch/iPhone/iPad.
2
Select Philips DCW8010 XXXXXX from
the list of available networks.
Philips DCW8010 XXXXXX
Advertisement
Table of Contents
