Bosch GSR 10,8 V-LIQ Professional Original Operating Instructions page 9

OBJ_BUCH-756-002.book Page 9 Monday, June 9, 2008 2:18 PM
Technical Data
Cordless Drill/Driver
Article number
Rated voltage
No-load speed
Max. torque for
hard/soft screwdriv-
ing application ac-
cording to ISO 5393
Max. drilling dia.
– Steel
– Wood
Max. screw dia.
Chuck clamping range
Drill spindle thread
Weight according to
EPTA-Procedure
01/2003
Please observe the article number on the type plate of
your power tool. The trade names of individual tools may
vary.
Assembly
Battery Charging (see figure A)
Use only the battery chargers listed on the
accessories page. Only these battery charg-
ers are matched to the lithium ion battery of
your power tool.
Note: The battery is supplied partially charged.
To ensure full capacity of the battery, completely
charge the battery in the battery charger before
using your power tool for the first time.
The lithium ion battery can be charged at any
time without reducing its service life. Interrupt-
ing the charging procedure does not damage the
battery.
Bosch Power Tools
The lithium ion battery is protected against deep
discharging by the "Electronic Cell Protection
(ECP)". When the battery is empty, the machine
GSR 10,8 V-LIQ
is switched off by means of a protective circuit:
Professional
The inserted tool no longer rotates.
3 601 J92 2..
V= 10.8
chine has been automatically switched off. The
rpm 0 – 500
battery can be damaged.
To remove the battery 8, press the unlocking but-
tons 7 and pull out the battery downwards. Do
not exert any force.
Nm 18/7
The battery is equipped with an NTC tempera-
ture control which allows charging only within a
mm 6
temperature range of between 0 °C and 45 °C. A
mm 18
long battery service life is achieved in this man-
mm 6
ner.
0.8 – 6.0
mm
Observe the notes for disposal.
1/2"
Changing the Tool (see figure B)
kg 0.9
Hold the rear sleeve 3 of the keyless chuck 1
tightly and turn the front sleeve 2 in rotation di-
rection
the tool.
Hold the rear sleeve 3 of the keyless chuck 1 tight
and firmly turn the front sleeve 2 in rotation di-
rection
Replacing the Drill Chuck
For power tools without spindle lock, the drill
chuck must be replaced through an authorized
after-sales service agent for Bosch power tools.
Do not continue to press the
WARNING
On/Off switch after the ma-
Before any work on the power tool (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the center posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
, until the tool can be inserted. Insert
by hand.
The drill chuck must be tightened with a
tightening torque of approx. 20–25 Nm.
2 609 140 527 | (9.6.08)
English | 9