Cub Cadet Series 060 Operator's Manual page 8

3
Setting Up
Your Yard
Vacuum
NOTE: The bag/chute
switch button attached
to the mounting
bracket must be fully
depressed by the tip of
front tab on bag handle
when securing the bag
or engine will not start.
A
Align pin
with this
hole.
Figure 3-
A
B
Figure 3-6
B
A
Figure 3-
Attaching The Hose Assembly
5. a. Slide hose adapter of hose assembly into the
b. Pull spring loaded pin out on the base and align pin
c. Release the pin to lock the hose in place.
6. a. Snap the hose handle first into the upper hose
B
b. Lay hose tubing on hanger bracket next to chipper
Attaching The Bag
7. Grasp bag handle with one hand and slide locking rod
on mounting bracket with other hand toward engine.
Use the end of mounting bracket as leverage when
sliding the locking rod.
a. Slip bag over the rim of the discharge opening and
b. Snap bag clip to the top of the lower handle.
c. Place the lower straps on the bag over the top
NOTE: The bag/chute switch button attached to the
mounting bracket must be fully depressed by the tip of
front tab on bag handle when securing the bag or engine
will not start.
C
8
base adapter located on the left front of the Yard
Vacuum. See Figure 3-5.
with the first hole (closest to the end of the tube) in
the hose adapter.
handle bracket and then into the lower hose handle
bracket. See Figure 3-6.
chute.
release locking rod to secure bag in place. See
Figure 3-7.
of lower handle, hooking them on the studs. See
Figure 3-7.