Fastening The Dishwasher To The Cabinet; Installing The Toe Kick - Asko Dishwasher Installation Instructions Manual

FASTENING THE DISHWASHER TO THE CABINET

It's necessary to fasten the dishwasher to the cabinet so
it won't tilt when the door is opened or if something heavy
is placed on the door. Use only the stainless steel screws
provided with the machine.
1. Use option A for U.S. or European
standard installations. Use option B only
for European standard installations, or
U.S. installations where there is a hard
2
counter-top such as tile or marble.
1
2. Cover the screw heads with the plastic
plugs provided with the machine.
3. When the machine is properly attached,
check that the feet are tight against the
4x / 3x
floor and that the machine is level.
NOTE:
Be sure to use white spacers to keep from over-tightening
the mounting screws.

INSTALLING THE TOE KICK

TYPE A
The toe kick is attached with two screws that can only be
adjusted vertically.
Page 12
3
2x
5
4
2x
NOTE:
1"
When it is not possible to attach the dishwasher to the
(25 mm)
cabinet or the underside of the counter top, you should
install tip guards to prevent the machine from tipping when
you open the door. Sold individually.
TYPE B
1. Press the grey catches towards each other to release
the toe kick brackets.
2. Pull out the toe kick brackets as far as the installation
requires to provide the proper toe kick depth.
3. Once the toe kick brackets are at the appropriate
depth, press the grey catches away from each other
to lock the toe kick brackets in place.
4. The back side of the toe kick has hooks that will hang
the toe kick on the toe kick brackets. Lift the toe kick
up and let the hooks slide onto the brackets as you
lower the toe kick to the floor.
Customer Care Center
1-800-898-1879
www.askousa.com
Tip Guards
(P/N 8070851)