Unit Dimensions And Parts Arrangement - Lennox Dave Signature Collection XC15 Installation Instructions Manual

Unit Dimensions − Inches (mm) and Parts Arrangement
DISCHARGE AIR
39.40"
(1003)
SIDE VIEW
UNIT SUPPORT FEET
16−7/8
(429)
8−3/4
(222)
3−1/8 30−3/4
(79) (781)
BASE WITH ELONGATED LEGS
WARNING
This product and/or the indoor unit it is matched
with may contain fiberglass wool.
Disturbing the insulation
maintenance, or repair will expose you to fiberglass
wool dust. Breathing this may cause lung cancer.
(Fiberglass wool is known to the State of California
to cause cancer.)
Fiberglass wool may also cause respiratory, skin,
and eye irritation.
To reduce exposure to this substance or for further
information, consult material safety data sheets
available from address shown below, or contact
your supervisor.
Lennox Industries Inc.
P.O. Box 799900
Dallas, TX 75379−9900
506044−01 06/08
[−024] 41 (1040)
[−030 THROUGH −060]
SUCTION LINE
INLET
LIQUID LINE
INLET
CONTACTOR
SYSTEM OPERATION
RUN CAPACITOR
DISCHARGE LINE
26−7/8
(683)
SUCTION VALVE AND
GAUGE PORT
SUCTION LINE
LOW PRESSURE
3−3/4 (95)
FILTER DRIER
4−5/8
(117)
during installation,
Page 2
ELECTRICAL
INLETS
47 (1194)
18.60"
(470)
8.00"
(203)
1 (25)
MONITOR
MUFFLER
SWITCH
XC15 PARTS ARRANGEMENT
DO NOT REMOVED THE THREE VIBRATION ISOLATOR SLEEVES (IF
PRESENT) FROM THE COMPRESSOR DISCHARGE LINE
Figure 1. Discharge Line Vibration Isolators
35.50"
(902)
ACCESS VIEW
OUTDOOR FAN
COMPRESSOR
AND SOUND
REDUCTION
COVER
COMPRESSOR
TERMINAL PLUG
HIGH PRESSURE
SWITCH
VIBRATION ISOLATOR SLEEVE
LOCATIONS ON −024, −030 AND
−036.
NOTE: ON THE −042, ALL THREE
VIBRATION ISOLATOR
SLEEVES ARE LOCATED ON
THE HORIZONTAL SECTION OF
THE DISCHARGE LINE.