Panasonic Toughbook CF-71 Series Operating Instructions Manual page 8

First-time Operation
2
Open Slot
4
Tab
Label-side up
Flat Cable
Tab
Press down on these areas firmly.
2
1
8
Insert a thin, flat object, like a ruler into the open slot on the left side of the com-
Cover
2
puter.
3
3 Open the cover.
4 Pull the tab outside the frame of the computer, and insert the non-connector-side of
the battery pack into the computer with the label- side up.
Connector
5 Insert the connector-side of the battery pack into the computer to secure the connec-
5
tor.
CAUTION
Be sure the battery pack is properly connected to the connector.
If the tab is set under the battery pack, the battery pack will be difficult to
remove later.
Do not touch the battery connector on the computer and flat cable. The com-
puter may not operate properly.
Close the cover until it clicks into place; be sure the tab does not get caught when
6
closing the cover.
6
CAUTION
When closing the cover;
Be careful not to get your fingers
caught in the cover.
There are instances the right side
of the cover will float. In such
cases, attempt to close the cover
again by pushing the projection.
3
Connect your computer to a power outlet
CAUTION
Be sure the AC adapter is connected until completing Step 8 on page 10.
Handling the AC adapter
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adapter with your computer. Using an AC adapter
3
other than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord
from your AC wall outlet.
Problems such as sudden voltage drops/surges may arise during periods of thun-
der and lightning. Since this could adversely affect your computer, an
uninterruptible power source (UPS) is highly recommended unless the battery
pack is installed.
Projection