D-Link DWC-1000 User Manual page 254

Wireless Controller
User Manual
Mode: OpenVPN daemon mode. It can run in server mode, client mode or access
server client mode. In access server client mode, the user has to download the a uto
login profile from the OpenVPN Access Server and upload the same to connect.
Server IP: OpenVPN server IP address to which the client connects(Applicable in
client mode).
VPN Network: Address of the Virtual Network.
VPN Netmask: Netmask of the Virtual Network.
Port: The port number on which OpenVPN server (or Access Server) runs.
Tunnel Protocol: The protocol used to communicate with the remote host. Ex: TCP,
UDP. UDP is the default.
Encryption Algorithm: The cipher with which the packets are encrypted. Ex: BF -
CBC, AES-128,AES-192 and AES-256. BF-CBC is the default
Hash algorithm: Message digest algorithm used to authenticate packets. Ex: SHA1,
SHA256 and SHA512. SHA1 is the de fault.
Tunnel Type: Select Full Tunnel to redirect all the traffic through the tunnel. Select
Split Tunnel to redirect traffic to only specified resources (added from OpenVpnClient
Routes) through the tunnel. Full Tunnel is the default.
Enable Client to Client communication: Enable this to allow OpenVPN clients to
communicate with each other in split tunnel case. Disabled by default.
Upload Access Server Client Configuration : The user has to download the auto
login profile and upload here to connect this controller to the OpenVPN Access
Server.
Certificates: Select the set of certificates OpenVPN server uses. First Row: Set of
certificates and keys the server uses. Second Row: Set of certificates and keys newly
uploaded.
Enable TLS Authentication Key: Enabling this adds TLS authentication which adds
an additional layer of authentication. Can be checked only when the TLS key is
uploaded. Disabled by default.
Click Save Settings to save the configuration entered.
253