Recording; Basic Recording For Video - JVC GR DVL 200 Instructions Manual

14
EN
Power Switch
Power lamp

Recording

Start/Stop Button
Display
min
90 min
(Now calculating)
0 min
(Blinking)
Tally lamp
(lights while recording
is in progress)
BR I GHT –
180
90
PUSH OPEN Button
Lock Button
During
shooting
2 5
Tape remaining
time indicator
(Approximate)
3 min
89 min
1 min 2 min
(Blinking) (Blinking)
MENU/
BRIGHT Wheel
+
VIDEO/DSC Switch
RECORDING
NOTE:
You should already have performed the procedures listed
below. If not, do so before continuing.
Power ( pg. 6)
Grip Adjustment (
Viewfinder Adjustment (
Load A Cassette (
Recording Mode Setting (
1
Press in the tabs on the lens cap to remove it. Press
PUSH OPEN, open the LCD monitor and set the
VIDEO/DSC Switch to "VIDEO".
2
Set the Power Switch to "
down the Lock Button located on the switch.
Shooting while using the LCD monitor: Make sure
the LCD monitor is fully open. Tilt it upward/
downward for best viewability.
Shooting while using the viewfinder: Close the LCD
monitor.
•The power lamp lights and the camcorder enters the
Record-Standby mode. "PAUSE" is displayed.
3
Press the Recording Start/Stop Button. "
while recording is in progress.
To Stop Recording . . .
.... press the Recording Start/Stop Button. The camcorder
re-enters the Record-Standby mode.
To Adjust The Brightness Of The Display
.... rotate MENU/BRIGHT until the bright level indicator
on the display moves and the appropriate brightness is
reached.

Basic Recording For Video

pg. 8)
pg. 8)
pg. 10)
pg. 11)
" or " " while pressing
" appears