Scsi; Kbd - Akai S1000 Series Operator's Manual

MIDI
There is no receive key, as reception of bulk data will automatically take place once a remote
device initiates the dump protocol

SCSI

This only applies if you have a S1000 fitted with the SCSI interface board (IB-103). On this
page you can enable or disable MIDI bulk data transmission along a SCSI bus, rather than the
MIDI connections, and set the SCSI IDs for both the S1000 and the other SCSI device. The
other SCSI device can be another of the S1000 series or a personal computer (equipped with
the appropriate software). Values for SCSI device IDs can be from 0 to 7. The two values
must be different, otherwise no communication will take place.

KBD

This page exists, but serves no function on the S1000 series. Since the S1000KB uses the
same operating system software, this page is available only for use with a S1000KB.
Page 68
Version 2.0 89/11