Automatic Editing To Vcr - JVC 1000MKV*UN*VP Instruction Manual

Original tape (camcorder)
1 3
IN OUT IN OUT
Edited tape (VCR)
STOP (5) Button
REW (2) Button
PAUSE (6) Button
Power Switch
Recording Start/Stop Button
Remote Sensor

AUTOMATIC EDITING TO VCR

2
9
IN OUT
10
11
12
NOTES:
If you performed step 1
CONNECTIONS"), keep the remote control pointed at
the VCR during editing.
The on-screen display only appears while the camcorder
searches for each scene.
There may be noise at in- or out-points on the edited
tape with certain VCRs.
RM-V700U
(optional)
VCR REC STBY
ON/OFF
Rewind the tape in the camcorder to the beginning of
the scene you want to edit and press PAUSE.
Point the remote control towards the VCR's infrared
sensor and press VCR REC STBY, or manually engage
the VCR's Record-Pause mode.
Press the Recording Start/Stop Button on the
camcorder to begin Automatic Editing, and the
previously selected scenes are copied to the VCR in
the specified order.
While editing, the R.A. Edit counter of the scene
which is being copied is shown with a blinking
highlight.
•Pressing START/STOP on the remote control does
not start editing.
When all selected scenes have been copied, the
camcorder and VCR enter the Still or Pause mode.
Press STOP on both units. To make the R.A. Edit
counter display disappear, press ON/OFF.
•When finished editing, be sure to disconnect the
editing cable and the A/V cable.
43
EN
on page 41 ("MAKE