Table of Contents
Advertisement
Parts and Components
(The numbers refer to the corresponding numbers in the figure.)
3D Glasses (1) (Fig. -1)
Power Button
Power on: Press once
Power off: Hold power button down for 2 seconds (LED flashes three
times and turns off )
* Auto power off: More than 5 minutes without IR signal
LED indicator
When operating, the indicator lights up green.
Flashes once every 2 seconds: Battery operation
Flashes three times every 3 seconds: Low battery – Charge the battery
When charging, the LED indicator lights up yellow. (When charge is
completed, the indicator turns off.)
Note
When operating: the indicator lights up green and the battery cannot
be charged.
IR Sensor
Receiving IR (infrared rays) signals are emitted from the front of the
3D Sync Transmitter.
IR's entry angle differs according to distance and/or usage
environment.
Note
Please keep the IR Sensor clean.
Connector for charge
Charge the battery. When charging, open the cover.
USB charging cable (1.2 m) (1) (Fig. -2)
Pouch (1) (Fig. -3)
Charging the battery
To prevent battery deterioration, charge the battery at least once every
half a year or a year.
1
Turn the 3D Glasses power off.
2
Plug the USB charging AC power adaptor supplied with the projector
into an AC outlet.
3
Connect the 3D Glasses and the USB charging AC power adaptor
with the supplied USB cable. (Fig. )
Open the cover.
Connect the USB cable.
Connect to the USB charging AC power adaptor.
When connecting this product and the USB charging AC power adaptor
with USB cable, this product will start to charge. (When charging, the
LED indicator lights up yellow.)
If you turn the power of this product on when charging the battery,
charging will be stopped. (When operating, the indicator lights up green.)
Troubleshooting
In the event of a problem, refer to the projector's instruction manual.
Specifications
Mass
59 g (2.1 oz.)
Battery Type
Built-in lithium-ion rechargeable battery
Operating time
Approx. 30 hours
Charging time
Approx. 30 minutes (in case of charge with the
USB charging AC power adaptor supplied with
the projector)
* Quick charge: approx. 3 minutes charge
enables approx. 3 hours use.
Dimensions (w × h × d) Approx. 174 × 44 × 185 mm (6
inches)
Operating temperature 0°C to 40°C (32°F to 104°F)
Operating humidity
20% to 80%
Design and specifications are subject to change without notice.
7
3
3
/
× 1
/
× 7
/
8
4
8
Advertisement
Table of Contents
